Quantum-composers 9500 Series SPROM Uživatelský manuál stáhnout pdf

9500 Series Pulse Generator

SPROM Replacement Guide

TN0003

TECH NOTE By: Jimmie Bates

This document is intended to walk an end-user through the procedure to replace the

SPROM programming IC in your Quantum Composers Pulse Generator. Only someone

familiar with handling of electronic equipment should perform the following procedure.

Please adhere to all safety precautions outlined in this document!

Introduction

Summary

po box 4248 - Bozeman MT 59772 - 406/582-0227 (ph) - 406/582-0237 (fax) - www.quantumcomposers.com

QC Family

9512, 9514, 9518

2) Disconnect any other instruments

connected to the Pulse Generator. This ensures the

protection of the extraneous instruments, the end-

user, and the Pulse Generator from damage caused

by inadvertent short circuits, etc.

3) Remove the front and rear bezels by pulling

away from the side of the Pulse Generator and

twisting the side of the bezel out.

4) Remove the top screws from the front & rear

panels.

1) Disconnect the power cord. The power

supply inside the Pulse Generator has exposed

surfaces that have live grid voltage when the unit is

plugged in. Electrical shock could occur if the unit

is not disconnected from the power source. You

must disconnect the power cord.

1 2

9500 Series Pulse GeneratorSPROM Replacement GuideTN0003TECH NOTE By: Jimmie BatesThis document is intended to walk an end-user through the procedu

po box 4248 - Bozeman MT 59772 - 406/582-0227 (ph) - 406/582-0237 (fax) - www.quantumcomposers.com5) Remove the top cover. Do this by inserting acoin

Žádné komentáře

Quantum-composers 9500 Series SPROM Uživatelský manuál