Quantum Composers 9730 Series Provozní pokyny stáhnout pdf (Strana 36)

10-36

System Pulse Commands

Keyword

Command

Sub

Command

Parameter

Range

Notes

:SPULse or

PULSe[0]

Subsystem. Contains commands to control the

output pulse generation. Commands without suffix

refer to the currently selected logical instrument.

See INSTrument subsystem.

:STATe 0/1 or

OFF/ON

Enables / Disables the output for all channels.

Command is the same as pressing the RUN/STOP

button.

:PERiod 1[us] – 200[s] Sets the T

period in seconds.

:MODe SINGle /

BURSt

Sets the T

generation mode.

:FSYNc DIS / T0 / CHA

/ CHB / etc.

Sets the pulse source for the front panel sync

output.

:RSYNc DIS / T0 / CHA

/ CHB / etc.

Sets the pulse source for the rear panel sync

output.

:TRIGger Contains the commands to define the Trigger

function.

:MODe 0/1 or OFF/ON Sets Trigger Mode. Disable or TRIG (enable).

:TSOurce FRONtpanel /

REARpanel

Switches the system trigger source between front

or rear panel inputs.

:EDGe FALLing /

RISing

Selects which edge (rising or falling) to use as the

trigger signal.

:LEVel 0.2 – 15[V] Sets the Trigger Threshold. Value is in volts, with a

resolution of .1 Volts.

:FENable 0/1 or OFF/ON Enables/Disables the trigger pulse width filter.

:FILTer .02 – 1000[us] Sets the trigger minimum pulse width value in

microseconds.

:COUNt Contains commands to manipulate the system shot

counter (T

pulses)

:STATe 0/1 or OFF/ON Enables/Disables the system shot counter.

:CLear 0 Clears the system shot counter.

:COUNt ? Query Only. Returns the value of the system shot

counter.

:PRETest ? Query Only: Returns the measured resistance

value for all channel with PreTest enabled in the

form of <n>:x.xx with each channel separated by a

single space (e.g. 1:1.99 2:2.00 4:2.01 if all

channels except channel 3 have PreTest Enabled)

:POSTtest

? Query Only: Returns the measured resistance value

for all channel with PostTest enabled in the form of

<n>:xxx.xx with each channel separated by a single

space (e.g. 1:149.99 2:147.00 4:150.01 if all

channels except channel 3 have PostTest Enabled)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Quantum Composers 9730 Series Provozní pokyny Strana 36

Komentáře k této Příručce