Quantum-composers Communications Terminal Program Uživatelský manuál stáhnout pdf

Using the Communications Terminal Program to Communicate with

Quantum Composer Pulse Generators

The Communications Terminal program is a convenient way to remotely interface with Quantum Composers

pulse generators and is provided with every pulse generator.

Installation

To install the Communications Terminal program run the “Serial Comm Terminal Setup” executable located on

the cd rom under Software\Comm Terminal. The program will be installed on to your hard drive under the

program files (x86) directory (\Program Files (x86)\Quantum Composers\Comm Terminal) in Windows 7 and the

standard program files directory for all other versions of Windows.

Figure 1

1 2 3 4 5

Strany 1

Using the Communications Terminal Program to Communicate with Quantum Composer Pulse Generators The Communications Terminal program is a convenient

Software Configuration Upon initialization of the software for the first time the program will state that a comm port needs to be selected. A comm

Communication Communicating with the pulse generator can be achieved in one of three ways; single commands sent manually, up to 5 commands sent in a

Figure 4 The command file will open in the lower right hand corner of the program and show the command list (Figure 5). Figure 5

Press the start button under the cycle controls to send the commands to the instrument. The commands and responses will appear in the lower left ha

Žádné komentáře

Quantum-composers Communications Terminal Program Uživatelský manuál