Quantum-composers 9500 Plus Series Uživatelský manuál stáhnout pdf (Strana 34)

Pressing the RUN/STOP key will now generate a continuous stream of pulses.

To Use Channel Single Shot Function

The Single Shot mode generates a single pulse every time the RUN/STOP key

is pressed. If the unit is in the active state, ( i.e. channels which are set to the

Normal mode are producing pulses), pressing the Function key and RUN/STOP

key will reset the Single Shot counters and generate one pulse in sync with the

other channels running in the Normal mode. To use the Single Shot mode:

- Within the Channel menus

Enable: Select Enable to enable channel output.

Delay: Set the desired delay.

Width: Set the desired pulsewidth.

Mode: Select the Single shot mode.

To Use Channel Burst Mode Function

The Burst mode generates a burst of pulses every time the RUN/STOP key is

pressed. If the unit is in the active state, (i.e. channels which are set to the

Normal mode are producing pulses), pressing the “FUNCTION - RUN/STOP”

key sequence will reset the Burst counters and generate a new set of pulses in

sync with the other channels running in the Normal mode. “FUNCTION - RUN/

STOP" will not affect T

pulse status. To use the Burst mode:

-Within the Channel menus

Enable: Select Enable to enable channel output.

Delay: Set the desired delay.

Width: Set the desired pulsewidth.

Mode: Select the Burst mode.

#/Burst: Set the number of pulses to produce in the burst.

To Use the Channel Duty Cycle Function

To generate a stream of pulses which oscillates on for ‘n’ pulses and off for 'm'

pulses:

- Within the Channel menus

Enable: Select Enable to enable channel output.

Delay: Set the desired delay.

Width:

Set the desired pulsewidth.

Mode: Select the Duty Cycle mode.

On Cycle: Set the number of pulses to produce during the on

cycle.

Off Cycle: Set the number of pulses to skip during the off cycle.

Note: Older Quantum Composers pulse generators had a divide-by-n

function. The duty cycle mode is a more general case. To reproduce the

divide-by-n function, set the on cycle to 1 and set the off cycle to (n-1),

where “n” is the divide-by-n factor.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Žádné komentáře

Quantum-composers 9500 Plus Series Uživatelský manuál Strana 34