Quantum-composers 9530 Series Uživatelský manuál Strana 42
- Strana / 71
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Page 42 9530/8530 Manual Version 4.8
:INFOrmation
?
Query only. Returns model,
serial number, firmware
version, and FPGA version
numbers. The same as the
*IDN? Command.
:NSID
?
Query only. Returns firmware
and FPGA identification
numbers.
:CAPS
0/1 or OFF/ON
The default value is 1, which
means the unit is not case
sensitive. 0 means the
commands sent to the unit
must be capitalized.
*Note: To change this
parameter the unit must be
power cycled before the
command will take effect.
IEEE 488.2 Common Commands
Command:
Parameter Range:
Notes:
*IDN
?
Query only. Returns model, serial number, firmware version, and FPGA
version numbers.
*RCL
1 - 24
RECALL
*RST
RESET. Resets parameters only same as *RCL 0
*SAV
1 - 24
SAVE
*TRG
Creates a soft trigger input.
*TTG
Creates a soft trigger for the trigger input only. Used when the dual trigger
option is enabled.
*GTG
Creates a soft trigger for the gate input only. This command is only active
when the dual trigger option is enabled.
*LBL
?
Used to query the label of the last saved or recalled configuration.
String Value
Command to attach a string label to the current settings. The string must
be in double quotes and no longer than 14 characters. Command must be
followed by a *sav [1/2/n] command to take effect.
*Note: To see the label on the screen a display update or reboot must take
place.
*ARM
0/1 or OFF/ON
Resets all channel counters simultaneously when the channels are in
either single shot or burst mode.
*Note: The system must be in continuous mode (this command is
functionally the same as pressing the Run/Stop button).
- Operating Manual 1
- Contents 2
- 1. Introduction 6
- 2. Safety Issues 7
- 3. Front Panel Overview 8
- Operations 9
- 5. 9530 Menus 13
- Press the Page Button 14
- 9530 Channel Menu Structure 15
- Change Gate Mode 16
- Clock/Rate Menu 17
- System Configuration Menu 18
- Recall Menu 20
- Counter Menu 20
- Store Menu 20
- System Information Menu 21
- Mode: Disabled 24
- Change Trigger Mode 24
- Mode: Triggered 24
- Level: 2.50 Volts 24
- Edge: Rising/Falling Edge 24
- Gate Menu 25
- 6. Operating the 9530/8530 26
- System Timer Overview 27
- Channel Timer Overview 28
- External Input Overview 29
- Termination 32
- IEEE 488.2 Common Commands 42
- 9530/8530 Specifications 43
- Safety Marking Symbols 46
- 10. Appendix C - COM 48
- Determining IP address 49
- Figure 3: Serial Ports page 50
- Figure 4: Baud rate settings 51
- DT15 Dual Trigger Module 54
- 13. Appendix F – Impedance 56
- Matching 56
- Appendix G - Increment Mode 57
- 8530 Board Level Overview 61
- Mounting Information 65
Související produkty a manuály pro Generátory Quantum-composers 9530 Series
(9 stránky)Apex Digital Registratori Video Digitali (DVR) manuali utente
Partendo da A
Komentáře k této Příručce